BROADCAST TRANSMITTERS                          

DEDICATED TO THE CONTINUED SUPPORT OF RCA BROADCAST TRANSMITTERS

KITS ISSUED EXCLUSIVELY FOR G-LINE LOW BAND TRANSMITTERS.

MI-563391-1 NOT ISSUED

MI-563391-2 AMPLIFIER AIR DUCT DAMPER ROD KIT.     DATE ISSUED - 1/15/81

PURPOSE - TO PROVIDE POSITIVE LOCKING OF AIR DUCT DAMPER ADJUSTING ROD.  THIS IS ACCOMPLISHED BY CHANGING THE ROUND ADJUSTING ROD AND ASSEMBLY THAT PROJECTS FROM THE SIDE OF THE AIR DUCT AND INSTALLING A NEW ASSEMBLY WITH A RECTANGULAR ADJUSTING ROD.

MI-563391 -3 LOW BAND SYNTHESIZER - TEMPERATURE COMPENSATION.  DATE ISSUED - 2/6/81

PURPOSE - TO PROVIDE THE MATERIAL AND INSTRUCTIONS NECESSARY TO MODIFY THE VISUAL AND IF OSCILLATORS IN THE VISUAL SYNTHESIZER CHASSIS SUCH THAT THE OSCILLATORS ARE TEMPERATURE COMPENSATED OVER EXTREME AMBIENT TEMPERATURE CHANGES.  THIS IS ACCOMPLISHED BY CHANGING THE WHITE CERAMIC CHIP CAPACITORS C10 AND C11 IN THE VCO BOARD TO 18 PF N0470 TC CAPACITORS.  CAPACITORS C10 A ND C11 IN THE IF BOARD ARE CHANGED TO 24 PF N0470 TC CAPACITORS.

MI-563391-4 BLOWER INLET DAMPER KIT.  DATE ISSUED - 2/3/81

PURPOSE - TO PROVIDE AIR FLOW CONTROL ON BLOWER INLET AND REDUCE AIR TURBULENCE.  THIS IS ACCOMPLISHED BY PUSHING THE EXISTING DAMPER CONTROL ROD IN AS FAR AS IT WILL GO TO OPEN THE BLOWER OUTLET DAMPER FULLY.  A NEW ADJUSTABLE PLATE IS THEN ATTACHED TO THE INLET SIDE OF THE BLOWER AND ADJUSTED FOR CORRECT AIR FLOW.  

MI-563391-5 NOT ISSUED

MI-563391-6 FILAMENT CAPACITOR WIRING KIT.  DATE ISSUED - 7/28/81

PURPOSE - TO PROVIDE THE MATERIAL AND INSTRUCTIONS NECESSARY TO INSTALL HEAVIER GAUGE WIRE IN THE CONNECTIONS BETWEEN THE VISUAL AND AURAL TUBE FILAMENT POWER SUPPLIES FERRORESONANT TRANSFORMERS AND THE RELATED CAPACITORS.  THIS CHANGE WILL PERMIT THESE WIRES TO RUN AT A LOWER TEMPERATURE WITH INCREASED RELIABILITY.